Target group
This training module is intended for technicians who commission an MD2400SA fire detection system and/or perform service and maintenance work on an MD2400SA fire detection system.
This training is not aimed at technicians who already hold an “MD2400/MD2400L – Initial Training” certificate or an “MD2400/MD2400L – Customised Programming” certificate. Training of the MD2400SA for technicians who already have the above mentioned certificates is organised at the customer’s office in consultation with the Limotec bv commercial representative.
Prior knowledge
Prior knowledge of the MD2400 and MD2400L fire detection system is not required. However, trainees do have a good basic knowledge of electricity and know the basics of analogue addressable fire detection systems.
Purpose of training
The MD2400SA initial training course is a theoretical course for commissioning and maintaining a standard MD2400 and MD2400L fire detection system. This course does not include any practical exercises.
During the course, the trainee is introduced to the various components of the MD2400SA fire detection systems. Connection of detection loops, repeater panel(s) to the I/O bus and output wiring on a C.I.E. MD2400SA are covered. Connecting, addressing and analogue values of standard analogue addressable components are also part of this MD2400SA initial training course.
The initial training covers the programming of a simple fire detection system with the default controls and online functions for testing and maintaining an MD2400SA fire detection system.
During the training, the connection between the trainee’s computer and an C.I.E. MD2400SA is tested. In order for this test to run smoothly, the trainee provides a computer with the MD2400SA configuration software, an active MD2400SAL licence file and a cable “USB-A to Mini USB”.
IMPORTANT: no software will be installed and/or licence file created on the day of training. These things will be taken care of by the trainee before the day of the training! To guide you in this, the trainee will receive a message several days before the training with the installation files of the MD2400SA configuration software and a manual with the necessary instructions.
Agenda
- Composition of the C.I.E. MD2400SA
- Basic connections of the C.I.E. (detection loops & standard output wires)
- Connection and configuration of the MD2400SA repeater panel to I/O bus of the MD2400SA
- Connection and addressing of the common SOTERIA components to the CORE loop interface card:
SOTERIA base
SOTERIA Optical smoke detector
SOTERIA Heat detector
SOTERIA Multisensor detector
Addressable manual call point
Intelligent input/output units
XP95 Sounder - Summary of analogue values and fault search.
- Various screens and menus of the C.I.E. MD2400SA
- Wizard for commissioning an C.I.E. MD2400SA
- Programming of detector and group names
- Programming of detector groups
- Adjustment of the “Type” parameter for the common SOTERIA and addressable components
- Explanation of the default controls in combination with the “Evacuation immediate” and “Evacuation delayed” functions.
- Overview of the various basic functions and parameters of the MD2400SA configuration software
- The online function “Detector test” for the purpose of testing the MD2400SA fire detection system
Evaluation & Training certificate
At the end of this MD2400SA initial training course, the knowledge acquired will be evaluated by means of a theoretical test. Trainees achieving a score of at least 60% will receive the certificate “MD2400SA – Initial Training” a few days after the training.
All training courses
MODULE 1 : MD2400/MD2400L - initial training
MODULE 2 : MD2400/MD2400L - customised programming
MODULE 3 : MD2400/MD2400L - specific training
MODULE 4 : MD2400SA - initial training
MODULE 5 : MD780 - initial training
MODULE 6 : MD2400SA - quick guide
MODULE 7 : MD2400 - infosession generation 3